Silicone mold Pumpkin in a hat

Silicone mold is suitable for soap and candles.
The mold can also be used for pouring plaster/concrete, for creating decorative products.
Required equipment: formwork with clamps and rubber bands.

The mold has one original cut, it can be uneven or straight. This is the norm, depending on the complexity of the mold, and is not considered a defect (defect). Its presence is a technical necessity for easy removal of the product.
If you need a mold without cuts, be sure to write to us about it in the order comment.

Heat resistance from -40°C to +200°C.
The color or shade of the silicone mold may be different. This will not affect the quality of the finished product.

More molds at the link – silicone molds for Halloween candles.
For the silicone mold, order – KeraSoy Pillar 4120 soy wax;

Dimensions of the finished product:

Width – 57 mm;

Length – 57 mm;

Height – 73 mm;

The weight of the candle is 70 g.
 

Use and Care:
Preheat the mold with a hair dryer to avoid temperature dissonance, and coat it well with Silicone Spray for easy product removal and mold maintenance. During pouring, we advise you not to drag the mold with rubber bands to avoid direct deformation of the mold and the candle.
After each pouring, wash the mold well using a detergent in warm water, wait for complete drying and store the mold in a dry place, without direct sunlight.
 

Be sure to test the first filling of the mold without a puncture, to evaluate the finished product.
Learn more about exchanges and returns.