Silicone mold Bento-carrot 12 cm + formwork

The silicone mold is suitable for candles.
The mold can also be used for pouring plaster/concrete, to create decorative products.
 

The mold formwork can be either two or four parts, depending on the specifics of the print. This is the norm and is not considered a defect!
The kit includes rubber bands and binders. It is recommended to first tighten the mold with rubber bands, and then put on binders for a stronger compression.

The collapsible 3D mold consists of two halves of the silicone part and two plastic formworks, which securely fix the mold during pouring. This design provides precise geometry, ease of use and a perfect surface of the finished product.

Package contents:
• 2 halves of the silicone mold
• 2 plastic halves of the formwork

Heat resistance from -40°C to +200°C.
The color or shade of the silicone mold and formworks may be different. This will not affect the quality of the finished product.

Molds from this collection –  Table candles.
To the silicone mold, order – Soy wax KeraSoy Pillar 4120 and Candlestick "Jug" (with a hole), Candlestick "Jug" low (with a hole).

Dimensions of the finished product:

Height – 120 mm;

Diameter – 15,5 mm;

Bottom diameter – 11 mm;

Candle weight – 11 g.

Use and Care:
Preheat the mold with a hair dryer to avoid temperature dissonance, and coat it well with Silicone Spray for easy product removal and mold maintenance. During pouring, we advise you not to drag the mold with rubber bands to avoid direct deformation of the mold and the candle.
After each pouring, wash the mold well using a detergent in warm water, wait for complete drying and store the mold in a dry place, without direct sunlight.
 

Be sure to test the first filling of the mold without a puncture, to evaluate the finished product.
Learn more about exchanges and returns.